Cleveland Flash & Fire point Apparatus

Cleveland Flash & Fire point Apparatus: MTBA -07

FLASH POINT

The flash point of a material is the lowest temperature at which the application of test flame causes the vapors from the material to momentarily catch fire in the form of a flash under specified conditions of the test.

FIRE POINT

The fire point is the lowest temperature at which the application of test flame causes the material to ignite and burn at least for 5 seconds under specified conditions of the test.

The material is filled in the cup up to a filling mark the lid placed to close the cup in a closed system all accessories including thermometer of the specified range are suitably fixed the bitumen sample is then heated the test flame is lit and adjusted in such a way that the size of a bleed is of 4 mm diameter the heating is done at the rate of 5 degree c to 6 degree c per minute the stirring is done at a rate of approximately 60 revolutions per minute the test flame is applied at intervals depending upon the expected flash and fire points first application is made at least 17 degree c below the actual flash point and then at every 1 degree c to 3 degree c the stirring is discontinued during the application of the test flame.

Features:-

Cup fitting handle
Cup cover with test flame and shutter mechanism
thermometers
Heat element
Long life
Superior finish
Easy to operate

Description

Technical Specification:-

Cleveland Flash Point Apparatus electric heated with voltage cardiac copper coil type.
Thermometer 28C Range -6 to 400C
Polished carrying wood case
Spare cup with handle only.
The apparatus consists of a cup heating plate to specific dimensions thermometer clip and test flame attachment with swivel joint for passing over liquid surface in the prescribed manner
Heater is controlled by means of different types of regulators fitted to the apparatus suitable for operation on 220 Volts AC mains.
Ignition Automatic
Heating Power of Furnace 400 W
Temperature Adjustment Controlled Silicon (Continuous)
Power 220 V, 1 ph, 50 / 60 Hz

Accessories:-

Lab coats
Heating source
Timer
Goggles
Kerosene sample
Closed panicky martens
Flame Gas Regulator

** Note:-The content of the product and specification are subject to change without prior notice for continuous improvement. Images shown are for representation purpose only. “MICROTEKNIK “keeps the right to modify the content in the product without prior notice.